The motor speed cannot follow a specified speed. An excessive motor load torque is detected. The acceleration/deceleration time in parameter No. 4082 is insufficient. 1 Check and correct the cutting conditions to decrease the load. 2 Correct parameter No. 4082. Spindle ...
ASKCNC Latest Questions
Alarm 935 highlights memory corruption, which can lead to unstable CNC behavior, loss of part programs, or even controller failure. It must be resolved promptly and correctly to avoid downtime and data loss.
Are there any software updates or firmware patches available to address the “SP9006 THERMAL SENSOR DISCONNECT” issue? Is there any preventive maintenance that can be performed to reduce the likelihood of future thermal sensor disconnects?
What causes the SSPA:19 Excess Offset Current U error on Fanuc CNCs? Is the SP9019 SSPA:19 Excess Offset Current U error related to electrical issues?
Have any changes been made to the wiring or connections of the position sensor recently? Amplifier indication 21
Fanuc Spindle Alarm SP9001 is an alarm code that indicates a problem with the spindle on a Fanuc CNC machine. When this alarm occurs, it means there is an issue with the spindle rotation or control system.
SP9017 Serial Spindle Alarm error on Fanuc: Recommended troubleshooting tips. What does the SP9017 Serial Spindle Alarm mean on a Fanuc machine?
What are the potential causes and solutions for the “SP9004 SSPA:04 POWER SUPPLY ERROR” message? Understanding the impact of this error on machine performance is crucial. Exploring diagnostic steps, such as testing the power supply unit, can pinpoint the source ...
Are specific error codes or indicators associated with the “SP9013 SSPA:13 CPU DATA MEMORY FAULT” issue? What steps can be taken to diagnose the root cause of the CPU data memory fault? How can the impact of the “SP9013 SSPA:13 ...
What is the purpose of the F0.4 signal in a FANUC PLC ladder program, and how does it affect machine control? How is the F0.4 flag used in FANUC PLC programming to indicate a specific machine or system condition?